- MICROSOFT SURFACE NETWORK ADAPTER NOT WORKING INSTALL
- MICROSOFT SURFACE NETWORK ADAPTER NOT WORKING FREE
If TCP/IP is not installed, click Install, click Protocol, and then click TCP/IP.ĭ. In the Properties window, make sure that the Internet Protocol (TCP/IP) is installed.Ĭ. Right-click the appropriate Local Area Connection and select Properties. The network card should be presented as Local Area Connection.ī. Right-click the My Network Places icon and select Properties. Verify TCP/IP (or other appropriate protocol) is properly installed: You can check this under Microsoft Windows:Ī. All IP addresses should be unique and DHCP is set correctly to automatically obtain a TCP/IP address.Ħ. Check network settings within the operating system: Ensuring all protocols and network hardware are set correctly (cables, hubs, switches, etc.).
MICROSOFT SURFACE NETWORK ADAPTER NOT WORKING FREE
Disable any unused devices to free up resources (serial ports, parallel ports, and so forth).ĥ. Look under Advanced Setup/PCI Slot/Device Information (or PCI Bus Control) and select the slot or device to be changed.Ĭ. Press F1 at bootup to enter the Setup/Configuration Utility.ī. These settings can be hard-set within most server BIOS programs.Ī. A NIC should not share an IRQ with SCSI or RAID controllers if possible. Check the operating system for resource conflicts: Verifying whether there are resource conflicts between the NIC and some other system component. If “This device is working properly” is shown on that page, it proves that the network card is still working if not, there might be some specific problems with your card.Ĥ. Then, you can see the network card status on the General tab. After that, double-click your network adapter entry. Click Network Adapters in Device Manager to expand this section. Input “devmgmt.msc” in the box and click the OK button to open Device Manager.Ĭ. Press Win+R on your keyboard to quickly summon the RUN box.ī. If not, you go to the next part directly: Troubleshoot Network Adapter Problems Through Software.Ī. Check your network adapter status: You can use Device Manager to verify whether the network card is identified by your computer or server via the following steps. Unsolved either, then you need to confirm the compatibilities of cables and network devices connected with your adapter to see whether their brand, data rate, and port type are matched.ģ.
MICROSOFT SURFACE NETWORK ADAPTER NOT WORKING INSTALL
If you don’t have a new NIC or cable, you can just install the card in another computer or server. If the problem is still unsolved and you happened to have extra cables and NICs, you can change new cables or NIC cards to verify whether the cables and NICs are damaged.
Firstly, you can try to insert cables or adapters in different ports or slots to see whether the ports or slots are damaged. There may be a problem with either the network devices or the network itself. Check the LED indicators of your network cards: If the link LEDs fail to light, it means the physical connection is inaccessible to the network. If your NIC is still unable to connect with your network, you can move to step 2.Ģ. You can try to unplug the cards and insert them again. Check all the physical connections: Making sure all the network cables or optical cables and network cards are firmly and properly seated in ports or slots without loose or unplugged. If the network adapter is not working, you can begin with the following hardware troubleshooting steps:ġ. Troubleshoot Network Adapter Problems Through Hardware
0 kommentar(er)
